Lillypilly patina copper sheets12/26/2023 ![]() 2 flat buttons, one medium size and one small – to use as templates for rounded edges.#0000 steel wool (a few small pieces) – for smoothing the edges and surfaces of your bracelets.(Find them at jewelry suppliers, hardware stores, and home improvement stores.) Tin snips, metal shears, or other scissors that can cut 22 or 24 gauge metal.Ultra-thin Sharpie marker – to mark your copper sheet.Ruler – to measure and mark your bracelets on the copper sheet.Many craft-store and hardware-store metals have been varnished). (If you’re going use a patina, alcohol ink, or some other finish on your bracelets, make sure your copper has NOT been varnished. ![]() Most jewelry suppliers that carry metalworking stuff carry sheet metal. So to make these 3 bracelets, you’ll need a piece of copper sheet that’s at least 1″ (25mm) wide (1/4″ + 1/4″ + 1/2″) and as long as your wrist measurement minus half an inch (13mm).Įxample: If you want to make these 3 bracelets and you have an 8″ (20.32 cm) wrist, your copper sheet should be at least 1″ x 7.5″ (2.5 cm x 19.05 cm). In this tutorial we’ll make 3 cuff bracelets: I like stacking one fancy cuff with two plain ones – but you could also create a stack where each bracelet has a unique, special design.Īnd if you’re selling them displayed as interesting stacks or mix-and-match deals, you will probably have a lot of people looking at them. Make a fashionable stack of copper bracelets – there are endless ways to mix and match a collection of cuffs! ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |