Hot water heater overflow pipe12/27/2023 So what's the right and easy way to do this? I've had very good luck with compression fittings. But, I can't find the 3/4-3/4 male NPT coupling fitting to tie the female flex pipe into the female valve.ģ/4 pipe → 3/4 compression female to NPT male → NPT female to NPT female valve → NPT female valve to NPT male-male coupling → NPT male-male coupling to NPT female flex pipe.Īnd none of these parts are carried by anyone retail store. So, it seems I could go from 3/4 to NPT right away. I assume this is a bad idea? I've ruled this out. What does exist is compression-compression-valves, but in this configuration I'm adding two more compression rings per side of the water heater which is far from ideal. This valve doesn't exist, but such a setup would result in one compression rings per water line. Ideally, there would be a combo-valve that would go from 3/4 compression to thread, and then from a mail thread I could use a flex pipe to go right to the heater. Is there anything wrong with this idea? Moreover, what kind of valves and adapters do I use? I'd like to cut them off, and put on a compression fitting and flex tube to the water heater. From that point there are a series of elbows and a valve I don't trust taking the copper pipe to the water heater. Water heater manufacturers state that a TPR discharge pipe is required to direct hot water to the exterior or a suitable drain location. I have 3/4 ID (inner diameter), 7/8 OD (outer diameter) feeding the water heater. A correctly installed TPR discharge pipe directs this scalding water to discharge to a safe location to the exterior or drain location. This pipe is responsible for routing hot water released from the TPR to a proper discharge location. What I'd like to do rather than soldier the pipes together is to go from compression to thread. The valve should be connected to a discharge pipe (also called a drain line) that runs down the length of the water heater tank. I'm buying a new water heater, and quite frankly the series of connections and valves are mind boggling.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |