Codelink v2 memory bar plugin1/2/2024 ![]() ![]() The direction the needle is traveling can be changed by clicking on the arrows on either side of the bar.Īfter you start the program, while you are being traced, the program charge will begin to increase. ![]() The needle will also wrap around from right to left and or left to right with the appropriate increase or decrease in trace time. As the needle approaches the right side the seconds will increase and decrease towards the left. The bar below the delay percentage will have a needle on it and display a trace time, in seconds, in the middle. These are both tied to the charge time on the Trace Delay program. After clicking the Start button, while being traced, a percentage will be displayed at the top and a progress bar at the bottom. The Trace Delay program can be run at any time, but it can only be activated while an active trace is in progress. There is only one version level of this program. This program has no effect on passive traces. The delay charge time is affected by the processors on your system and additional and/or more powerful CPUs will improve the Trace Delay significantly. Trace Delay works equally well when you are performing attacks with the Diagnostics Module. The increased trace time can help you finish a tough mission and later allow you to perform more missions in a single connection. ![]() The Trace Delay program will allow you to throw off the authorities and increase your active trace time while hacking. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |